Disclaimer: The information on this page has not been checked by an independent person.   Use this information at your own risk.
ROYMECH

Home
Fluids Page
Back to Pumps

Peripheral Pumps /Regenerative Pumps

Peripheral Pumps / Regenerative Pumps

Note: In the sections below this type of pump is designated a regenerative pump..

The regenerative pump produces large head at comparatively small flows.    The design of the pump includes for a special impeller with a large number of radial blades.   As the fluid is discharge from one blade it is transferred to the root of the next blade and given additional energy.   The fluid heads developed in this type of pump can be very high and the pump should not be used without a close coupled relief valve in the system.

In a regenerative pump, liquid enters and exits the pump during several revolutions of the impeller.   The velocity and pressure increases of the liquid are therefore gradual compared to the centrifugal pump.   Liquid entering the pump near its vapor pressure is less likely to experience the pressure change that can cause cavitation due to the smaller pressure gradient.   Therefore, regenerative pumps, typically, require lower net positive suction heads than centrifugal pumps.

This pump is generally made from special materials to combat the corrosive conditions resulting from the high degree of turbulence experienced within the casing.   The figure below shows in outline the operating principles of the peripheral pump.


Peripheral Pumps

Comparison between Regenerative and Centrifugal Pumps

1) The regenerative pump can handle liquids with 20% entrained gases.   Under the same conditions a centrifugal pump would experience vortexing or cavitation.

2) If the fluid supply source runs dry the regenerative pump cavity remains filled with liquid, unlike centrifugal pumps.   This allow the pump to operate under dry suction conditions in this event.

3) The regenerative pump is capable of reversible impeller rotation, with an accompanying reversal of the suction and discharge porting.

4) The head capacity curve of a regenerative turbine pump has a different shape compared to a centrifugal pump. It is nearly linear sloping downward.    At lower heads, the flow is typically much smaller than for a centrifugal pump.   The slope never approaches a horizontal plane.   Therefore, throttling a valve for a regenerative pump will permit more precise changes in flow, without major overshooting or undershooting of the duty point.

Regenerative Pump Curve





Useful Links
  1. Dynaflow Engineering .. Pump supplier Providing useful notes comparing Centrifugal and Regenrative Pumps
  2. mth Pumps.. Useful relevent information. USA (imperial units)
  3. Consider regenerative pumps for low-flow/low-NPSH applications .. Very Interesting Paper
  4. ChemPump regenerative-turbine pump .. Technical Data sheet TDS-012NPSH & Regenerative Turbine Pumps

Home
Fluids Page
Back to Pumps


This Page is being developed

Send Comments to Roy Beardmore

Last Updated 25/01/2013